testing facilities

We at Epoxy House use the best available testing facilities for Electrical, Mechanical & other required test for Insulators, Bushings CTS & PTS. We have partial discharge detector model 5 from world best manufacturer Robinson, UK. For Ratio & Phase angle measurement of CTs & PTs we are using world favorite Olman Canadian comparator. We have High voltage testing facilities up to 170KV which is suitable to test Electrical components up to 66KV system voltage. Our High voltage sources are discharge free for partial discharge measurement of Bushings, Insulators CTS & PTS up to 66KV system voltage.

We have the heat distortion temperature measurement oven to find the proper polymerization of various systems of Resins with Hardners. We can also do all mechanical test like Impact strength, compression strength flexural strength, Cantilever strength etc. on universal testing machine.

Our next door is 'ERDA' an independent test laboratory who can test all electrical & mechanical routine & type test required for our range of products. They can carry out the test as per DIN, IEC, UL, ANSI, BS, VDE or another equivalent standard including temperature cycle test from -25°C to 105°C. They can also carry out short circuit test up to 80KA/1sec & impulse test up to 1200 kV peak.

We can test all incoming materials like copper-rods, flats section etc for conductivity, and chemical composition, Hardness of the material. Copper wires are also tested for resistance measurement, enamelling adhesion test, coating thickness of enamel on wire, breakdown voltage test, roundness of conductor etc. We can also test plating thickness or paint thickness of ferrous parts using nondestructive method by imported instrument & also plating thickness of non-ferrous parts by 'GEDET' meter.

Our standard room at Epoxy House is Equipped with 'TESA' make digital 600mm Height gauge having 0.001mm accuracy, all standard Ring & plug GO / NOGO thread gauges & bore gauges. Our test labs are Equipped with additional testing facilities for CTS, PTS, Coils etc to test shorted turns using shorted turns meter, No of turns measurement, Surge Comparison test & temperature rise test up to 10,000 Amps capacity.

We carry out all necessary and final in-process check as per our standard written procedure manual required as per ISO 9001 quality procedure guide line to maintain consistent high quality standard of our products. Our testing engineers are well qualified & thoroughly trained at professional training center like ERDA, Baroda time to time.

We are quite confident to offer world class Resin cast products up to 66KV system voltage for switchgear & transformer Industries, by using almost all in-house test facilities & support from independent test lab.